Logic Analyzer Probing Support Products
CAN Bus
Our ATM-1 trigger module product facilitates probing of the CAN bus using
Tektronix TLA5xxx/6xx/7xx/7xxx logic analyzers having 34 or more channels.
Mictor probe use is directly supported; compression probe use requires
a "Mictor-on-the-PCB" adapter.
Further information regarding the ATM-1 trigger module itself can be found in the
Oscilloscope Support Products area of the website
here.
Download the ATM-1 logic analysis support datasheet (PDF file, less than 5 MB).
Download the ATM1/ATM1C disassembler users' manual here (Version 1.010; ZIP file, less than 12 MB).
Download the ATM-1 LA Setup application here (Version 1.0; ZIP file, less than 1 MB).
Download the ATM1 disassembler here (Version 1.100; ZIP file, less than 1 MB).
Download the ATM1C disassembler here (Version 1.100; ZIP file, less than 1 MB).
Note that ATM-1 firmware Version 1.13 is required for use with the above disassemblers, with Version 1.14 (or later) recommended.
Download ATM1C sample acquisition files here (ZIP file, less than 2 MB).
|
